250V attribut :
-
Additional thermostat shaft rotary switch, 20A 250-400V
These on-off switches are designed to be added on thermostat shafts. They provide off position when the thermostat shaft is at the minimum position. They are available in single pole contact, two poles (one level) and three poles or four poles contact (two levels).
-
Adjustable electronic manual reset limiter for immersion heater IP66, IK10
-Equipment requesting a very strong resistance to water ingress. The transparent cover allows to visualize the set point and the 2 pilot lights Fully wired electronic temperature control sub assembly for direct mounting on immersion heater elements, 1”1/2 or M45x2 with double thread or rotation ring. Applications in high temperature safety in usual industrial applications…
-
Adjustable manual reset electronic rod limiter IP66, IK10
- Equipment requesting a very strong resistance to water ingress. The transparent cover allows to visualize the set point and the 2 pilot lights. These electronic rod thermostats are installed inside pockets as immersion thermostats in pipelines and containers, and for monitoring temperature in air ducts. - Manual reset allows the use as high temperature…
-
Adjustable manual reset electronic room limiter IP66, IK10
- Equipment requesting a very strong resistance to water ingress. The transparent cover allows to visualize the set point and the 2 pilot lights. Wall mounting for indoor or outdoor high temperature alarm of cold High temperature alarm of industrial or commercial Outdoor temperature alarm of antifreeze High temperature alarm of green houses and livestock
-
Adjustable manual reset remote sensor electronic limiter IP66, IK10
- Equipment requesting a very strong resistance to water ingress. The transparent cover allows to visualize the set point and the 2 pilot lights. -Use of electronic sensor allows measurement at long distances, which is not possible with bulb and capillary types. - Manual reset allows the use as high temperature alarm
-
Bulb and capillary manual reset limiter IP66, IK10
Equipment requesting a very strong resistance to water ingress. The transparent cover allows to visualize the set point and the 2 pilot lights Remote control in usual industrial applications and environments, not hazardous areas, for use as high limit safety. Sealed temperature set point.
-
Dia. 10mm cartridge thermostat 1/2″BSPT or M14x1.5 fitting, calibration from 50 to 120°C
Detection of a temperature value in liquids, water, hydraulic oils, thermal oils. Two versions of electrical contacts: Gold-plated for low power circuit, like PLC or 2A 250V for relay coils or resistive circuits.
-
Din rail mounting miniature humidistat for electrical cabinets
Main Application: condensation in electrical enclosures and cabinets can be critical for electrical components and safety. This humidistat is designed to switch on a heater or a ventilating fan when the relative humidity raises at dangerous levels, when there is a risk to reach the dew point usually around 65%.