Brass Tees for 3/4″BSPP female nut, DN15, PN25
Raw material |
---|
Description
![]() |
![]() |
¾” BSPP male Tee, brass, DN15-PN25 |
|
Reference | 6R1TB3434 |
Downloadable
Datasheet
RELATED PRODUCTS
-
Paddle flow switches, reed switch contact, built-in 16A SPDT relay
General application in flow detection. Recommended mounting position is on horizontal pipes, but can be mounted in any position. For water flow detection on dia 15 to 100mm water pipes. The built-in relay with SPDT contact can be used on resistive loads up to 15A 250V. The pilot light shows the contact position.
SIMILAR PRODUCTS
-
Paddle flow switches, reed switch contact, 1/2” male thread, long paddle
€31.20 – €33.60Main uses: The most simple flow switch with magnetic pull-back. Recommended mounting position is on horizontal pipes, but can be mounted in any position. For water flow detection on dia. 25 to 63 mm water pipes.
-
T connection box for heat tracing cables with wall mounting bracket
This box allows to connect, with a good IP66 ingress protection, 2 rounds or flat heating cable to a round power cable or providing at the same time the continuity of the power line. Terminals positions provide easy access, wiring is simple, including for braided heating cables.
-
T connection box for heat tracing cables with antifreeze thermostat
This box allows to connect, with a good IP66 ingress protection, 2 rounds or flat heating cable to a round power cable or providing at the same time the continuity of the power line. The built-in disc thermostat provides the anti-freeze function. Terminals positions provide easy access, wiring is simple, including for braided heating cables.
-
Tee connection box for heat tracing cables
This box allows to connect, with a good ingress protection (IP66) , end-to-end, on field, a round or flat heating cable to a round power cable, and providing at the same time the continuity of the power line. An example of this type of connection is the feeding of heated drinking troughs in stables or…
-
Deep drawn immersion heater fitting
304L or 316L stainless steel, with gasket and rotation ring for 1, 2 or 3 heating elements This set, more economical than machined solutions, allows the installation of an immersion heater entirely of stainless steel on any enclosure, and requires only a dia. 75 mm drill on the bottom of the enclosure, the same as…
Technical informations associated to this product
-
Flow switches technical foreword
A certain force is required to actuate the electrical contact device. It can range from a few tenths of grams for systems with reed contacts with a power rating of 10 to 20VA (0.5Amp), to 50 grams for snap action micro-switches with a 5Amp 250V rating